.HEX Maps for TuneECU and Custom PCIII Maps Downloads

Done a good mod that people might want to copy? Post it here - full step-by-step instructions and pix.

FAQs can go in here too
druu
Minimoto racer
 
Posts: 16
Joined: Wed Jan 01, 2014 6:07 am
Location: Perth, Australia

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby druu » Fri May 11, 2018 11:16 am

jambox wrote:
druu wrote:I posted in the other thread but figure I'd post here too:
....... .

Thanks in advance!

PM me your email and I'll sent you a couple of maps to try.

Some on here have used mine in the past with some good results.


PM'd!

User avatar
sam46
Two wheeled terror
 
Posts: 158
Joined: Fri May 17, 2013 4:16 pm
Location: wales - uk

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby sam46 » Wed May 16, 2018 6:47 pm

Any fresh links to this map - 08 SDGuysCustom possibly the best map for aftermarket pipes .hex
Link on the first page is dead :(

Also after recommendations for this setup (for when i finish mods)

07 EU SD
Akro Evos
Ramair pods (guessing these are rotty equivelent or close)
2nd flies removed

Cheers
07 SD 990 - Akros - Awaiting major mods
05 SD 990 - RamAir pods - Akro Ti - Sold
07 SD 990 - Superduke heaven RIP
KTM 250SXF, KTM 300EXC, KTM 450SMR, CRF450, KTM 250XCF, YZF R1 09, YZF R1 03, YZF R6 02, YZF R1 98

User avatar
Aphex
Site Admin
 
Posts: 1971
Joined: Tue Nov 06, 2012 5:08 pm
Location: So Cal

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby Aphex » Wed May 16, 2018 10:09 pm

sam46 wrote:Any fresh links to this map - 08 SDGuysCustom possibly the best map for aftermarket pipes .hex
Link on the first page is dead :(

Also after recommendations for this setup (for when i finish mods)

07 EU SD
Akro Evos
Ramair pods (guessing these are rotty equivelent or close)
2nd flies removed

Cheers


Here is a link to my google drive where the maps are hosted: https://drive.google.com/drive/folders/ ... sp=sharing

The map youre looking for is in the TuneECUmaps.zip file. Just download it and unzip it.
08 SD, Mivv Suono, Rottweiler airbox. Current map: One some guy sent me from the internet.

Me so Hoony.

User avatar
sam46
Two wheeled terror
 
Posts: 158
Joined: Fri May 17, 2013 4:16 pm
Location: wales - uk

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby sam46 » Thu May 17, 2018 10:25 am

Tidy cheers boss
07 SD 990 - Akros - Awaiting major mods
05 SD 990 - RamAir pods - Akro Ti - Sold
07 SD 990 - Superduke heaven RIP
KTM 250SXF, KTM 300EXC, KTM 450SMR, CRF450, KTM 250XCF, YZF R1 09, YZF R1 03, YZF R6 02, YZF R1 98

User avatar
Aphex
Site Admin
 
Posts: 1971
Joined: Tue Nov 06, 2012 5:08 pm
Location: So Cal

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby Aphex » Thu May 17, 2018 2:29 pm

sam46 wrote:Tidy cheers boss


One day I'll rehost the individual maps and sort out the front page of this thread.
08 SD, Mivv Suono, Rottweiler airbox. Current map: One some guy sent me from the internet.

Me so Hoony.

User avatar
jambox
Trackday hero
 
Posts: 2023
Joined: Sun Oct 04, 2009 9:18 pm
Location: Perth. The shite cold one, not the decent warm one

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby jambox » Fri May 18, 2018 7:54 am

druu wrote:

PM'd!

Sorry for the delay. I've sent them to you.
05/06 SD, too raw for the journos!

User avatar
Tyler Durden
Minimoto racer
 
Posts: 33
Joined: Sun Sep 02, 2018 8:23 pm

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby Tyler Durden » Mon Sep 10, 2018 12:14 pm

Is it ok to flash my 2005 Super Duke with maps labelled 2006?

I have a completely stock bike that I am looking for a smoothened map to flash with TuneECU.

Thanks

User avatar
nampus
Stunt rider
 
Posts: 769
Joined: Thu Nov 04, 2010 4:24 pm
Location: The Netherlands

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby nampus » Mon Sep 10, 2018 7:56 pm

You should be fine with the 06 maps. 05/06 was the same bike.
07 onwards is different.

User avatar
Tyler Durden
Minimoto racer
 
Posts: 33
Joined: Sun Sep 02, 2018 8:23 pm

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby Tyler Durden » Wed Sep 12, 2018 12:14 pm

nampus wrote:You should be fine with the 06 maps. 05/06 was the same bike.
07 onwards is different.


Thanks.
I've just read the current ECU on my bike and found it to have the KM610EU050E001Map which I believe to be the standard KTM map. I'm planning on mapping it with the 06_SD_standard_smoothened.hex found in the Zip file hosted by Aphex.

Has anyone else done this?

User avatar
Tyler Durden
Minimoto racer
 
Posts: 33
Joined: Sun Sep 02, 2018 8:23 pm

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby Tyler Durden » Wed Sep 12, 2018 1:09 pm

I have now looked into the differences between the stadrad and the smoothened maps (at least for my Standard 06 bike), and the differences are only seen in the 2nd Throttle table and the F-L Switch Table.

Can anyone shed some light on what the smoothened maps are effectively doing?

User avatar
No. 47
Master of the twisties
 
Posts: 2970
Joined: Sat Jan 10, 2009 5:14 pm
Location: London and Kent

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby No. 47 » Wed Sep 12, 2018 1:33 pm

As CK said in this first post:

These first maps are Akra maps that have been smoothed out by James aka MrZ32. They are the safest maps to use as there is no danger of them being lean. This is what he wrote about what has been done to the maps in another thread.

"I have left the akra fuelling alone but turned the o2sensors off, set the 2ndry flies to stay open always(for those that leave them in, but removing the altogether is best), I have also changed the f-l switchover so that the l map only runs at idle... 3-4K surging cured and lifting off the throttle doesn't quite have the same abruptness"
'08 ex-Battle race KTM Superduke 990 R No.47
'08 OE KTM Superduke 990 R
'01 Ducati 996S

User avatar
Tyler Durden
Minimoto racer
 
Posts: 33
Joined: Sun Sep 02, 2018 8:23 pm

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby Tyler Durden » Wed Sep 12, 2018 6:36 pm

Thanks for that.
I wasn't talking about the Akra maps, but I assume the same goes for the Standard maps too.

User avatar
jambox
Trackday hero
 
Posts: 2023
Joined: Sun Oct 04, 2009 9:18 pm
Location: Perth. The shite cold one, not the decent warm one

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby jambox » Sun Sep 23, 2018 6:23 pm

Tyler, what mods have you got?
05/06 SD, too raw for the journos!

User avatar
Tyler Durden
Minimoto racer
 
Posts: 33
Joined: Sun Sep 02, 2018 8:23 pm

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby Tyler Durden » Tue Oct 09, 2018 12:05 pm

jambox wrote:Tyler, what mods have you got?

Sorry for the delay.
At the time of typing my initial post I didn't have any mods.
I have since removed the SAS and fitted a straight through exhaust like the Akra.
I am going to flash the 06_Akra_slip_on_smoothened.hex would that be right?

User avatar
jambox
Trackday hero
 
Posts: 2023
Joined: Sun Oct 04, 2009 9:18 pm
Location: Perth. The shite cold one, not the decent warm one

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby jambox » Tue Oct 09, 2018 12:37 pm

Yeah that'll be a good one to go for.

Sent from my EML-L09 using Tapatalk
05/06 SD, too raw for the journos!

User avatar
Tyler Durden
Minimoto racer
 
Posts: 33
Joined: Sun Sep 02, 2018 8:23 pm

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby Tyler Durden » Tue Oct 09, 2018 12:42 pm

jambox wrote:Yeah that'll be a good one to go for.

Sent from my EML-L09 using Tapatalk


Thanks.
I'm confused about whether I need to tick, or untick any of these devices within TuneECU prior to downloading the map to the bike.

SAI
O2 Sensor
2nd Throttle
Idle
Speed Control
EPC

User avatar
jambox
Trackday hero
 
Posts: 2023
Joined: Sun Oct 04, 2009 9:18 pm
Location: Perth. The shite cold one, not the decent warm one

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby jambox » Tue Oct 09, 2018 1:46 pm

You don't want SAI (that's the SAS) or O2 sensors.

2nd throttle is the secondary flies, the smoothed map will keep them open, but if you untick it'll stop them moving.

Sent from my EML-L09 using Tapatalk
05/06 SD, too raw for the journos!

User avatar
Tyler Durden
Minimoto racer
 
Posts: 33
Joined: Sun Sep 02, 2018 8:23 pm

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby Tyler Durden » Tue Oct 09, 2018 6:26 pm

I went with this

SAI - Unchecked
O2 Sensor - Unchecked
2nd Throttle - Checked
Idle - Checked
EPC - Unchecked

I also increased the Rev Limit to 9900

User avatar
jambox
Trackday hero
 
Posts: 2023
Joined: Sun Oct 04, 2009 9:18 pm
Location: Perth. The shite cold one, not the decent warm one

Re: .HEX Maps for TuneECU and Custom PCIII Maps Downloads

Postby jambox » Wed Oct 10, 2018 7:29 am

Oh yeah forgot the EPC.

Yeah that's what you ticked/unticked.

Raising the revs is also a good shout (think that's where I put mine to as well). There was people running into problems going over 10k, but set at 9900 I never felt the need for higher.

Hope you feel contempt with the map, it might smell a little fuely, but you'll be pleased with the difference.
05/06 SD, too raw for the journos!

Previous

Return to How to do it!

Who is online

Users browsing this forum: No registered users and 3 guests