Bent shift lever linkage--how to fix?

Done a good mod that people might want to copy? Post it here - full step-by-step instructions and pix.

FAQs can go in here too
slfishf1
Minimoto racer
 
Posts: 7
Joined: Mon Aug 20, 2018 5:46 pm

Bent shift lever linkage--how to fix?

Postby slfishf1 » Tue Oct 09, 2018 10:51 pm

Took a spill last week. 2008 990 SD. Damage mostly minor except it appears the tabs holding shift linkage have been bent in toward swingarm vs linkage being parallel to same. Pics here: https://www.flickr.com/photos/fishergen ... 2041890694. Seeking recommendations re how to address. Just pry/hammer to straighten?

User avatar
weeksy
Master of the twisties
 
Posts: 3689
Joined: Sat Feb 16, 2008 11:22 pm
Location: Newbury, UK

Re: Bent shift lever linkage--how to fix?

Postby weeksy » Wed Oct 10, 2018 6:08 am

NAh, as they're cast, straightening them at the very least will fatigue them.

Personally i'd take it off, replace with another used one that's straight. It's likely your frame/mounts are fine, just the footrest assembly that's bent.
Current : 2008 SDR

BuddhaBiker
Minimoto racer
 
Posts: 10
Joined: Sun Nov 27, 2016 1:04 am

Re: Bent shift lever linkage--how to fix?

Postby BuddhaBiker » Wed Oct 10, 2018 5:11 pm

I did that on my Super Duke, but bent the rear brake pedal. I was told not to try to straighten it as it would probably break, so I replaced it.


Sent from my iPhone using Tapatalk Pro

BuddhaBiker
Minimoto racer
 
Posts: 10
Joined: Sun Nov 27, 2016 1:04 am

Re: Bent shift lever linkage--how to fix?

Postby BuddhaBiker » Wed Oct 10, 2018 5:12 pm

I was told it might not break right then, but people have had it break on them as soon as they got hard on the rear brake.


Sent from my iPhone using Tapatalk Pro

User avatar
No. 47
Master of the twisties
 
Posts: 2969
Joined: Sat Jan 10, 2009 5:14 pm
Location: London and Kent

Re: Bent shift lever linkage--how to fix?

Postby No. 47 » Wed Oct 10, 2018 5:48 pm

Can't tell from the photos but whenever I've binned mine, its the frame tabs that bend and they're relatively easy to bend back using long hardened bolts and a scaffolding tube - but I have Power Part rearsets on both which don't bend.
'08 ex-Battle race KTM Superduke 990 R No.47
'08 OE KTM Superduke 990 R
'01 Ducati 996S


Return to How to do it!

Who is online

Users browsing this forum: No registered users and 1 guest